Now this is bad news
Playing with the flying toy, I found out that there is no potentiometer to control the power of the output. The only signal that the receiver mounted on the disc receives is a on/off message. I have tried to twik the output voltage, but it only becomes a lower emitted message from the antenna.
So I rebuilt the radiocontroller, to try without computer or messy wires, and then I got the bad new. It is made to be controlled only by on and off. If you put the trigger halfway, the outpt wont change. That is why it was so difficult to keep it in position.
Below is a picture of the piece of the radiocontroller board that should control the output power. I did notice before, and I suspected it, but I wanted to try with the tester first.
The trigger part is nothing more than a switch, unfortunately, or at least on this model.
Forgive me for the bad graphic design, but here is what. If the trigger stays on the green part, the toy flyes, if on the red part it stays on the floor.
I don’t know if I should try with another model or remake the plan for the project.
No Comments
No comments yet.
Sorry, the comment form is closed at this time.